Cisco Catalyst 9800-L Series Hardware Installation Manual page 44

Day 0 CLI Wizard for the Controller
2. Typical
3. High
Enter your selection [2]: 3
Step 19
[Optional] Configure AAA servers:
Note
Configure AAA servers? [yes]:
Enter the AAA server address: 9.11.112.46
Enter the AAA key: ***
Do you want to add more AAA servers? [yes]:
Enter the AAA server address: 9.11.112.47
Enter the AAA key: ***
Do you want to add more AAA servers? [yes]: no
Note
Step 20 [Optional] Configure wireless network settings to configure WLAN information for an AP and client join:
Configure Wireless network settings? [yes]:
Step 21
[Optional] Configure an SSID for client join:
Enter the network name or service set identifier (SSID):
Choose the network type
1. Employee
2. Guest
If you choose Employee as the network type, the following options are displayed:
Choose the security type
1. WPA Personal
2. WPA Enterprise
Enter your selection [2]:
If you choose WPA2 Personal, you will need to enter a pre-shared key (ASCII).
Enter the pre-shared key (ASCII):
If you choose WPA2 Enterprise, you will be able to add multiple AAA servers.
Enter the AAA server address:
Enter the AAA key:
Enter more AAA server details? [yes]
If you choose Guest, you get to view the following options:
Please choose the security type:
1. Webauth
2. Authbypass
3. Consent
4. Webconsent
Enter the security type:
Step 22
[Optional] Configure a virtual IP address. The recommended virtual IP address is 192.0.2.1.
Cisco Catalyst 9800-L Wireless Controller Hardware Installation Guide
36
You can configure a maximum of 6 servers during Day 0 configuration.
The AAA servers are required for WPA2 Enterprise. In 17.4 release, you need to configure AAA
only in one place. If you follow Step 21, WPA2 Enterprise will not ask for AAA servers in Step
22.
Power Up and Initial Configuration