Troubleshooting - Hilti PP 10 Manual

▶ Observe the temperature limits given in the Technical Data section which are applicable to storage or
transport of the equipment.
▶ Check the accuracy of the equipment before it is used after a long period of storage or transportation.
6.3 Transport
Note
The batteries must be insulated or removed from the product before it is shipped or sent by mail.
▶ Use the Hilti packaging or packaging of equivalent quality for transporting or shipping your equipment.
6.4 Adjustment through the Hilti Calibration Service
Note
Companies certified in accordance with ISO 900x require a valid calibration certificate for the measuring
tools or equipment used.
After checking and adjustment, a calibration sticker will be applied to the laser range meter and a calibration
certificate issued providing written verification that the laser range meter operates in accordance with the
manufacturer's specification.

7 Troubleshooting

If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
E02/03
E99
ERROR
8 Disposal
WARNING
Risk of injury. Hazards presented by improper disposal.
▶ Improper disposal of the equipment may have the following consequences: The burning of plastic
components generates toxic fumes which may present a health hazard. Batteries may explode
if damaged or exposed to very high temperatures, causing poisoning, burns, acid burns or
environmental pollution. Careless disposal may permit unauthorized and improper use of the
equipment. This may result in serious personal injury, injury to third parties and pollution of the
environment.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative for further information.
In accordance with the European Directive on waste electrical and electronic equipment and its implemen-
tation in conformance with national law, electric tools or appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
18
Possible cause
Internal error
An internal memory problem has
occurred.
Moving the tool when in standby
mode
Action to be taken
▶ Switch the tool off and then on
again.
▶ This error message may be
displayed if the tool is moved or
shaken. If this is the case, avoid
movement.
▶ Switch the tool off and then on
again.
▶ Switch the tool off and then on
again and check that it is set up
correctly.