Troubleshooting; Disposal - Hilti PRI 36 Operating Instructions Manual

9 Troubleshooting

Fault
The display shows this symbol
en
The display shows this symbol
The display shows this symbol
The display shows this symbol
The display shows this symbol
The display shows this symbol

10 Disposal

WARNING
Improper disposal of the equipment may have serious consequences:
The burning of plastic components generates toxic fumes which may present a health hazard.
Batteries may explode if damaged or exposed to very high temperatures, causing poisoning, burns, acid burns or
environmental pollution.
Careless disposal may permit unauthorized and improper use of the equipment. This may result in serious personal
injury, injury to third parties and pollution of the environment.
Most of the materials from which Hilti tools or appliances are manufactured can be recycled. The materials must
be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back old tools and appliances for recycling. Ask Hilti customer service or your Hilti representative for further
information.
14
Printed: 14.04.2014 | Doc-Nr: PUB / 5162040 / 000 / 01
Possible cause
The button lock is active.
The PRA 36 has not been paired with
the PRI 36. In this case, the PRI 36 is
not shown in the display.
Invalid entry; the command is not
possible.
The tools are out of wireless commu-
nication range. The command is valid
but the tool doesn't react.
The tool is in sleep mode (it remains
in sleep mode for max. 4 h and then
switches itself off).
Fault.
Remedy
Deactivate the button lock.
NOTE
Both sides of the remote control /
laser receiver cannot be used at the
same time .
Pair the tools (see section 6.9)
Press a valid button.
Check to ensure there are no obstruc-
tions between the tools. Do not ex-
ceed the maximum wireless com-
munication range. For good wireless
communication the PRI 36 should be
positioned at least 10 cm (4") above
ground level.
Activate the tool by pressing the
"Sleep" button. Activate the tool
settings after activating the tool.
Contact Hilti Service.