Samsung NY63 875 Series User Manual page 45

Gliding Rack
• Gliding racks may be cleaned b y hand with an abrasive cleaner or steel wool.
During cleaning, be careful not to allow water or cleaner to enter the slides of the
rack.
To lubricate the slides
NY63T8751SS_AA_DG68-01218A-00_EN+MES+CFR.indb 45
1. Remove the rack f rom the oven. See
removing the gliding rack in the USING
THE GLIDING RACK section.
2. Fully extend the rack on a table or
countertop. Newspaper may be placed
underneath the rack for easy cleanup.
3. If there is debris in the slide tracks,
wipe it away using a paper towel. (Any
graphite lubricant wiped away must be
replaced - See steps 4 through 7.)
4. Shake the graphite lubricant before
opening it. Starting with the left (front and
back) slide mechanism of the rack, place
four (4) small drops of lubricant
on the two (2) bottom tracks of the slide
close to the bearing carriers.
5. Repeat for the right (front and back) slide
mechanism of the rack.
6. Open and close the rack several times to
distribute the lubricant.
7. Replace the cap on the lubricant and
shake it again. Turn the rack over and
repeat steps 3, 4, 5, and 6.
8. Close the rack, turn rack right-side-up
and place in the oven. See installing the
gliding rack in the USING THE GLIDING
RACK section.
NOTE
• Do not spray the gliding r ack with cooking
spray or other lubricant sprays.
English 45
2020-03-23 6:45:59