Table of Contents
Advertisement
HOW TO START THE ENGINE
Before cranking
1. Apply the parking brake firmly.
2. Turn off unnecessary lights and accessories.
3. Put the selector lever in "P". If you need to restart the engine
while the vehicle is moving, put the selector lever in "N". A starter
safety device will prevent the starter from operating if the selector
lever is in any drive position.
4. Depress the brake pedal and hold it to the floor until you are ready
to drive off.
Starting the engine
Before starting the engine, be sure to follow the instructions in
"Before cranking".
Normal starting procedure
The multiport fuel injection system/sequential multiport fuel
injection system in your engine automatically controls the proper
air−fuel mixture for starting. You can start a cold or hot engine as
follows:
1. With your foot off the accelerator pedal, crank the engine by
turning the key to "START". Release it when the engine starts.
2. After the engine runs for about 10 seconds, you are ready to drive.
STARTING AND DRIVING
If the weather is below freezing, let the engine warm up for a few
minutes before driving. Do not leave the vehicle while the engine
is warming up.
If the engine stalls ...
Simply restart it , using the correct procedure given in normal
starting.
If the engine will not start
See "If your vehicle will not start" on page 193.
NOTICE
D Do not crank for more than 30 seconds at a time. This may
overheat the starter and wiring systems.
D Do not race a cold engine.
D If the engine becomes difficult to start or stalls frequently,
have the engine checked immediately.
159
Advertisement
Table of Contents
