Zanussi ZFC51400WA User Manual page 19

Problem
The appliance is noisy.
Audible or visual alarm is on.
Power indicator light is flash-
ing.
The lid doesn't close complete-
ly.
The lid is difficult to open.
The lamp does not work.
The compressor operates con-
tinually.
There is too much frost and
ice.
Possible cause
There is no voltage in the
mains socket.
The appliance is not supported
properly.
The cabinet has been recently
switched on or the temperature
in the appliance is too high.
Large quantities of food to be
frozen were inserted at the
same time.
The lid has been left open for a
long time.
An error has occurred in meas-
uring the temperature or the
appliance is not working prop-
erly.
Food packages are blocking
the lid.
There is excessive frost.
The lid gaskets are dirty or
sticky.
The valve is blocked.
The lamp is defective.
Temperature is set incorrectly.
Large quantities of food to be
frozen were inserted at the
same time.
The room temperature is too
high.
Food placed in the appliance
was too warm.
The lid is not closed properly.
The lid is not closed correctly
or the gasket is deformed/dirty.
Solution
Connect to a different electri-
cal mains socket. Contact a
qualified electrician.
Check if the appliance stands
stable.
Refer to "High Temperature
Alarm" and if the problem still
occurs contact the nearest Au-
thorized Service Centre.
Wait a few hours and then
check the temperature again.
Open the lid only if necessary.
Contact the nearest Author-
ized Service Centre.
Arrange the packages in the
right way, see the sticker in the
appliance.
Eliminate excess frost.
Clean the lid gaskets.
Check the valve.
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait a few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food to cool to room
temperature before storing.
Check if the lid closes well and
the gaskets are undamaged
and clean.
Refer to "Opening and closing
the lid".
19