Ventilation Requirements; Operation; Switching Off - Zanussi ZFC51400WA User Manual

Climate
Ambient temperature
class
T +16°C to + 43°C
Some functional problems might occur
for some types of models when
operating outside of that range. The
correct operation can only be
guaranteed within the specified
temperature range. If you have any
doubts regarding where to install the
appliance, please turn to the vendor,
to our customer service or to the
nearest Authorised Service Centre.
The plug should be accessible after
installation.
ELECTRICAL CONNECTION
• Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.

OPERATION

CONTROL PANEL
1 2
1
0 2
7 3
6 4
5
SWITCHING ON
1
0
7
6
5
A. Temperature Regulator
B. Half Loaded position
3
2
A
B
3
4
C
• The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
• The manufacturer declines all responsibility if
the above safety precautions are not observed.
• This appliance complies with the E.E.C.
Directives.

VENTILATION REQUIREMENTS

The airflow behind the appliance must be sufficient.
1. Put the freezer in horizontal position on a firm
surface. The cabinet must be on all four feet.
2. Make sure that the clearance between the
appliance and rear wall is 5 cm.
3. Make sure that the clearance between the
appliance and the sides is 5 cm.
Temperature regulator
1
Power indicator light
2
High temperature alarm light
3
C. Full Loaded position
1. Insert the plug into the wall socket.
2. Turn the Temperature Regulator to the Full
Loaded position and let the appliance run for
24 hours to allow the correct temperature to be
reached before placing food inside.
The power indicator light will light up.
3. Adjust the Temperature Regulator according to
the quantity of the stored foods.

SWITCHING OFF

Turn the Temperature regulator to the "0" position.
15