jbc PHB-SA Manual page 5

w w w.jbctools.com
Changing PCBs of the same batch
The support lets you place PCBs of the same batch so as to always heat the same area.
Use the sliding guides to change the PCBs.
Removing the PCB Placing another PCB
Clamp knobs
Loosen one sliding guide, pull back and lift Position it and tighten the sliding guide knobs.
out the PCB.
Reworking large PCBs
Use the 4 caps to place larger PCBs than the PHB-SA Support or over 3mm thick.
Cap
PCB
Guide
1. Remove both guides by 2. Place the PCB on the 4 3. The PCB is ready to work.
untightening the 8 screws. rubber caps.
5