Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for jbc PHB-SA
Summary of Contents for jbc PHB-SA
- Page 1 Convection Preheater Support Ref. PHB-SA...
-
Page 2: Packing List
Packing List The following items should be included: Convection Preheater Support ......................1 unit Ref. PHB-SA Allen key ............. 1 unit Manual ............1 unit Ref. 0013754 Ref. 0016294 w w w.jbctools.com Convection Preheater Support Ref. PHB-SA... - Page 3 w w w.jbctools.com Features Slot clamps Sliding guides Rubber caps Allen key Heater Unit Clamp knobs...
-
Page 4: Height Adjustment
Height Adjustment It allows adjustment for 3 heights between the PCB and the Heating Area of the PHB-A Heater Unit. Low level 28 mm Medium level 38 mm 48 mm High level To change the height, do as follows: To raise the support, hold the base and pull up. To lower the support, press the button and push down. - Page 5 Position it and tighten the sliding guide knobs. out the PCB. Reworking large PCBs Use the 4 caps to place larger PCBs than the PHB-SA Support or over 3mm thick. Guide 1. Remove both guides by 2. Place the PCB on the 4 3.
-
Page 6: Maintenance
- Check periodically that the support is clean, especially the axes of the sliding guide. - Replace any defective or damaged piece. Use original JBC spare parts only. - Repairs should only be performed by a JBC authorized technical service. Axes of the sliding guides Safety It is imperative to follow safety guidelines to protect health and prevent electric shock, injury, fire or explosions. -
Page 7: Exploded View
w w w.jbctools.com Exploded View... -
Page 8: Specifications
6 mm Complies with CE standards. ESD protected housing. Warranty JBC’s 2 year warranty covers this equipment against all manufacturing defects, including the replacement of defective parts and labour. Warranty does not cover product wear or misuse. In order for the warranty to be valid, equipment must be returned, postage paid, to the dealer where it was purchased.