Hyundai CON 301 Instruction Manual page 23

Instructions for Use
Assembly of the heater
Before using the heater, the feet (supplied in the carton), must be fitted to the main unit. These
are to be attached to the base of the heater using the 4 self-tapping screws provided, taking
care to ensure that they are located correctly in the bottom ends of the heater side mouldings
Operation of the heater
1) Choose a suitable location for the heater, taking into account the safety instructions above.
2) Insert the plug of the heater into a suitable socket.
3) Turn the thermostat knob fully in a clockwise direction to the maximum setting.
4) Turn on the heating elements by the power switches on the side panel. For maximum heat
output turn both switch to ON.
Change of wattage:
Both switches OFF
First switch ON
Seconf switch ON
Both switches ON
5) When the desired room temperature has been reached, the thermostat knob should be
turned slowly anti-clockwise until the thermostat is heard to click off. After this the heater
will keep the air temperature in the room at the set temperature by switching on and off
automatically.
6) In it's minimum (fully anti-clockwise) position, the thermostat provides a frost guard position.
In this position (depending on the size of the room) the heater will maintain the temperature
above freezing.
Fan Operation
This is operated by means of the fan switch with the fan symbol along side it. The fan will only
operate with the thermostat in the "on" position and can be used when the heating elements are
"on" to blow warm air into the room. In warm conditions the fan can be used with the heating
elements "off" to blow cool air into the room.
Timer Operation
This unit has 24hr timer which has 96 segments around its circumference, each segment being
equivalent to 15 minutes of time. With the aid of this timer it is possible to preset the time and
duration of the period(s) that it is desired the heater will operate, in any 24hr period. The centre
of the timer has a 2 position slide switch. In the position denoted by the " " the timer will switch
the heater on and off at times set by the segments, (see setting the timer, below). The position
denoted by the "I", is a timer override position. The timer will continue to run but power will be
fed continuously to the heater. This enables the heater to be on all the time if required.
OFF
750 W
1250 W
2000 W
ENG - 23
ENG