Helmet Mounting Kit; Mounting Examples; Inserting The Micro Sd Card - Navig8r NAVSPORTMINI User Manual

HELMET MOUNTING KIT

1. Helmet Belt 3. Camera clip mount
4. Tilt Knob
2. Helmet Mount
Note: This bracket will only work with vented Helmets such as bicycle helmets.
Use the supplied strap to loop through the holes in your helmet and then through the long slots on the
helmet mount. Tighten as required. Then observe the steps in the previous section regarding adjustment.

MOUNTING EXAMPLES

* Actual accessories may differ from those depicted above

INSERTING THE MICRO SD CARD

Carefully push the memory card into the card slot, as shown in the diagram below (using your fingernail).
The Micro SD card will "click into place". To take the memory card out, gently press the end of the memory
card inward using your fingernail until a click is heard. An internal spring will then release the card.
Note: This camera has no built-in memory. A memory card is needed for operation.
Note 2: High Definition and High Frame Rate video capture devices, place huge demands on memory cards.
Pending your user settings, it is recommended that a CLASS 10 SD Card be used to avoid Read/Write
complications, which will appear as an error message on the screen during use. If you are not sure, please
test any lower class cards (Read/Write speed) in the device before use.
6