Table of Contents
Advertisement
CHARGING THE BATTERY
Turn the camera off and connect the USB cable to the camera and to your power source (i.e. in-car charger,
PC USB port or USB Mains Power Adaptor) The charging indicator light will turn RED. When the battery
charge is full, the light will turn BLUE. A typical full charge takes up to 4 hours.
WATERPROOF CASE OPERATION
1.
Use your fingertip to gently pull the release clamp back
2.
Inspect the rubber water seal gasket to ensure it is in good condition, and then insert the camera in the correct
orientation.
Note 1: You can test the gasket by closing the case without the camera inside and submersing it completely in a
bowl of water for a few minutes. Remove the case from the water, dry off the exterior with a towel, and then
open the case. If the interior is dry, the camera and case will be safe for use under water.
Note 2: Only two buttons are required for recording video and images: the Shutter Button, and the On/Off
button.
Note 3: Remember to select the desired Mode on the camera before closing the case.
HANDLEBAR / SEAT POST MOUNT
3. Bar Clamp Nuts
1.
Connect the bar clamp to your handlebar (4).
2.
Connect your camera to the camera clip (1) securely.
3.
Loosen the tilt knob (2) and adjust.
4.
After positioning tighten all clamp nuts. (3)
5.
Adjustments can be made on the fly at any time.
1. Camera clip mount
2. Tilt knob
4. Bar clamp
5
Advertisement
Table of Contents
