Charging The Battery; Waterproof Case - Navig8r NAVSPORT4KX2 User Manual

CHARGING THE BATTERY

Turn the camera off and connect the USB cable to the camera and to your power source (i.e. in-car charger,
PC USB port or USB Mains Power Adaptor) The charging indicator light will turn RED. When the ba�ery
charge is full, the light will turn OFF. A typical full charge takes up to 4 hours.
NOTE: The ba�ery does not need to be removed under normal usage and charging condi�ons. If
removed, please note the polarity of the ba�ery when re-inser�ng. Take note of the input voltage and
current required by this device when connec�ng an external charger.

WATERPROOF CASE

1. Use your finger�p to gently pull the release lock and clamp, in the direc�on of the arrow (on the
clamp)
2. Inspect the white rubber water seal gasket to ensure it is in good condi�on, and then insert the camera
in the correct orienta�on.
Note 1: You can test the gasket by closing the case without the camera inside and submersing it completely
in a bowl of water for a few minutes. Remove the case from the water, dry off the exterior with a towel, and
then open the case carefully. If the interior is dry, the camera and case will be safe for use under water.
Note 2: Only two buttons are required for recording video and images: the Shutter Button, and the On/Off
button.
Note 3: Remember, when the unit is turned OFF and ON again, the unit will default to VIDEO modes and
the default resolu�ons.
Shu�er Bu�on
On/Off Bu�on
Release clamp
Case Hinge
8