Tech4o Traileader Instructions Manual page 23

7.4 START THE ASCEnT/DESCEnT (AS/
DS) CALCuLATOR
The Traileader is equipped with an auto
ascent/descent calculator that keeps
track of your total vertical distance
ascended and descended. This feature
differs from the altitude difference
calculator in that it measures all vertical
travel, not just the vertical difference
between two points. Example: In the
course of a day hike, you ascend 500 ft.
to a small knoll and descend 1500 ft. into
a ravine. You then scale a steep 3000 ft.
incline to the summit. To end your hike,
you descend 2500 ft. back to the trail
head. Your total ascent is 3500 ft. and
your total descent is 4000 ft. Together,
they represent the total of vertical travel.
Access the Altimeter Display
for how to access the Altimeter display)
• Hold M for 3 seconds to enter Altimeter set
menu
• Press LAP/RST(DOwn) to scroll to AS/DS
• Press M to select AS/DS
• Press ESC to cancel and exit AS/DS
• Press ESC to exit Altimeter set menu
The
7.5 STOP THE ASCEnT/DESCEnT (AS/DS)
Access the Altimeter Display
• Hold M for 3 seconds to enter Altimeter set
• Press LAP/RST(DOwn) to scroll to AS/DS
• Press M to select AS/DS
• Press ESC to cancel and exit AS/DS
(See section 7.1.
• Press ESC to exit Altimeter set menu
* Press M to select Start
* Press ST/STP to begin recording and
exit Start
mountain icon will flash in altimeter
mode when AS/DS is on
CALCuLATOR
for how to access the Altimeter display)
menu
* Press M to select Stop
* Press ST/STP to end recording and
exit Stop
Note: The Ascent/Descent calculator will
turn off if you exit altimeter mode and do
not return within 24 hours.
(See section 7.1
23