Security Menu - Samsung N860 User Manual

the Mode field and the Base I/O Address field. Settings for the Base I/O
Address are 378 IRQ7(default), 378 IRQ5, 278 IRQ7, 278 IRO5, 3RC IRQ7,
and 3RC IRQ5. Settings for the Mode are Output only, Bi-directional, EPP
(enhanced parallel port), and ECP (extended capabilities port). Selecting the
ECP setting enables you to set the DMA Channel to 1, 2, or 3.
When the Parallel port field is set to Enabled, the computer's operating
system uses the default configuration or the configuration you choose. If you
select Disabled, you free up an IRQ for use by another device.
Floppy disk controller: Configures the floppy disk controller. The options for
this field are Enabled (default), and Disabled. When the Floppy disk
controller field is set to Enabled, the computer's operating system uses the
default configuration for the controller.
Local Bus IDE adapter: Enables the integrated IDE local bus adapters. Options
are Enabled (default), Disabled, Both, and Primary.
Large Disk Access Mode: Enables your computer's operating system to work
with drives larger than 540 MB. Choose DOS (default) for Microsoft operating
systems. Choose Other for any other operating systems.

Security Menu

Selecting Security from the menu bar displays the Security menu. Your computer's
advanced security system allows you to set two different passwords to prevent
unauthorized access to system resources, data, and System Setup. From the
Security menu, you can enable a boot password, disk access, a system backup
reminder, and a virus check reminder.
Security fields marked with an asterisk (*) can only be changed if you start System
Setup with a system supervisor password or if no passwords are in effect. You
cannot access these fields with a user password.
Set User Password: Enables you to set a user password to control access to the
system at boot. See "Creating a Password" on page 74 for instructions on setting a
password.The user password allows restricted access to the System Setup Security
menu; the user has access only to changing his own password and to enabling or
disabling Password on boot. A supervisor password must be set before a user
password can be set.
Using System Setup 69