Operation; Power Up Of The Instrument - ASSEMBLAD RPM 111 Operating Manual

ASSEMBLAD

5 OPERATION

5.1 WARNINGS AND PRECAUTIONS
- Verify that the voltage of the battery of the vehicle is that one prescribed in the
technical characteristics.
- Don't let the instrument at the direct sunbeam, verify that ambient temperature is
compliant with instrument data.
- Do not put the magnetic probe in particularly warm places of the motor (es. exhaust
manifolds)
- Do not remove the systems of protection and/or emergency from the equipment, do
not bring modifications to the aim of increase the use or the performances.
- Do not leave for too long time the instruments operative; turn off the instrument if
an immediate use is not previewed.
- Pay attention to the DANGER or ATTENTION when operating on the motor .
- Protect face, hands and feet with adapted apparel, to avoid contacts with the
superficial warmth which candles, radiators, pipes of the cooling system. The
catalytic stock-pots catch up the highest temperatures, can cause burn or fires. Do
not smoke and do not use free flames when you work on the motor.
- In the vehicles the cooling fan is independently active also when the engine is off:
be careful when it is operating near the fan.
- Do not pull sensors or interfaces from its cables but use their connectors, make
attention to do not pull the wires. The disconnection of wires is not covered by
warranty.
- Do not use the oil temperature sensor in water, flame or other but only into the
motor oil. The wrong use is not covered by warranty.
- The complete discharge of the battery reduces its capacity and can damage it.

5.2 POWER UP OF THE INSTRUMENT

Turn on pushing the key ON for about one second. Turn off pushing the key OFF, this key
is active after the start-up messages.
After measurement, turn off the instrument to don't discharge the battery.
After power on the instrument, on the LCD is reported the message for search the
connection with an USB port, if it is found there will be the message that this port is
configured, only in this condition the communication of data and the updated via USB is
working.
If the communication of data is made via bluetooth, the USB communication is not used.
ASSEMBLAD S.r.l. - 50013 Campi Bisenzio - Firenze - Italy
http:// www.assemblad.it - Mail to: info@assemblad.it
RPM 111 = Operating manual
8