Advertisement
ELECTRICAL CONNECTIONS
A
Typical connections
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Finally connect the wiring harness to the unit.
To subwoofer (see diagram
Antenna
terminal
Line out (see diagram
White with black stripe
White
Left speaker (front)
B
Connecting the external amplifiers and subwoofer
You can connect amplifiers to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
Front speakers
JVC Amplifier
Rear speakers
JVC Amplifier
C
Connecting the external components
When connecting the external components, refer also to the manuals supplied for the components and adapter.
CAUTION:
Before connecting the external components, make sure that the unit is turned off.
You can connect the following JVC components to the CD changer jack.
JVC component
CD changer (CD-CH)
You can also connect the following components through the various JVC adapters.
• Connection cords may need to be purchased separately.
Component
Bluetooth device
iPod
Portable audio player with line output jacks
Portable audio player with 3.5 mm stereo mini jack
When connecting more than one component (maximum: two), it is recommended that you connect the components in series as explained below.
When connecting two components in series
CD changer jack
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
*
1
Not supplied for this unit.
*
2
Before checking the operation of this unit prior to installation, this lead must be connected; otherwise, power
cannot be turned on.
*
3
Remote lead.
)
Rear ground terminal
15 A fuse
To external components (see diagram
)
Black
*
2
Yellow
Red
Blue
Blue with white stripe
Gray with black stripe
Gray
Right speaker (front)
Remote lead (blue with white stripe)
Adapter
Bluetooth adapter
Interface adapter for iPod
Line input adapter
AUX input adapter
A KS-BTA200
*
6
B *
CD-CH / KS-PD100 / KS-U57 / KS-U58
6
)
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
To the automatic antenna if any (250 mA max.)
To the remote lead of other equipment (200 mA max.)
Green with black stripe
Green
Left speaker (rear)
Y-connector (not supplied for this unit)
To the remote lead of other equipment or automatic antenna
if any
Front speakers
Model name
CH-X1500, etc.
To disconnect the connector
*
4
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint (if
coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
*
5
Signal cord (not supplied for this unit).
*
6
To use these components, set the external input setting correctly (see page 13 of the INSTRUCTIONS).
2
Ignition switch
Fuse block
Purple with black stripe
Purple
JVC Amplifier
Subwoofer
Model name
KS-BTA200
KS-PD100
KS-U57
KS-U58
Hold the connector tightly ( 1 ), then pull it out ( 2 ).
Right speaker (rear)
Advertisement
