Table of Contents
Advertisement
Section 7: Accessories Description
General Information
A wide range of accessories are compatible with all ZT30
series Automatic Transfer Switches regardless of nominal
rating, transition mode or construction. Each accessory
requires minimum number of fasteners and is mounted to the
List of Major Accessory Items
Below is a list of major accessories available for
ZT30 series Automatic Transfer Switch:
- Protective Shutter Assembly
- Wire Harness for Inverted Option
- Ground bar
- Thermostat and Heater
- Lug Option
- Battery Charger
- Surge Protective Device (SPD)
WARNING
Improper Installation
Operation and Maintenance
and maintain all electrical equipment.
Failure to comply with these instructions
could result in death or serious injury.
WARNING
Both power sources must
be disconnected before
installing accessories.
Zenith Automatic Transfer Switch
| new.abb.com/low-voltage
A. Protective Shutter Assembly
- Protective Shutter Assembly Installation Instruction
drawing (O-4105) is needed for this installation procedure.
- For eld installation, the Isolation ATS needs to be
removed to provide su cient working area. Refer to
Section 3, under "LIFTING AND MOUNTING
GUIDANCE – ATS" for lifting instructions.
B. Wire Harness for Inverted Option
- Consult factory for adapter harness part numbers.
C. Ground Bar
- Available with compression or mechanical lugs.
Consult factory for o ering.
D. Thermostat and Heater
- Refer to drawing 99R-1114 for available Thermoset
and Heater options.
E. Lug Option
- Refer to drawing O-4106 for available Mechanical Lug
options (1600-3000A).
- Refer to drawing O-4107 for available Compression Lug
options (1600-3000A).
F. Battery Charger
- Refer to drawing 99R-1166 for available Battery Charger
options and installation guidance.
G. Surge Protective Device (SPD)
- Refer to drawing 99R-1048 for available SPD options and
installation guidance.
56
Advertisement
Table of Contents
