ABB Zenith ZT30 Operation And Maintenance Manual page 51

Non-Bypass ATS
NAME
TB #1
NAME
G Output Strip
G Output Strip
Zenith Automatic Transfer Switch |
ITEM# DESCRIPTION
1 Engine Start - NC
2 Engine Start - COM
3 Engine Start - NO
4 Connected to Source 1 - NO
5 Connected to Source 1 - COM
6 Connected to Source 1 - NC
7 Connected to Source 1 - NO
8 Connected to Source 1 - COM
9 Connected to Source 1 - NO
10 Connected to Source 1 - COM
11 Connected to Source 2 - NO
12 Connected to Source 2 - COM
13 Connected to Source 2 - NC
14 Connected to Source 2 - NO
15 Connected to Source 2 - COM
16 Connected to Source 2 - NO
17 Connected to Source 2 - COM
ITEM# FACTORY SETTING
G 1 (NO/NC/Common) Load Shed from S2 (R15)
G 2 (NO/NC/Common) Alternative Source Fail to Start
G 3 (NO/NC/Common) S1 Failure
G 4 (NO/NC/Common) S2 Failure to Connect
G 5 (NO/NC/Common) Load Control 1
G 7 Disconnect Switch (DS)
G 8 Test with Load (Q2)
G 9 Load Shed from S2 (R15)
G 10 Bypass Xfer Time Delay to S1
G 11 Inhibit Xfer to S2 (Q3)
G 12 Inhibit Xfer to S1 (Q3)
G 13 Engine Start (SW1)
Com +24VDC
new.abb.com/low-voltage
Factory Use Only
Factory Use Only
Factory Use Only
Factory Use Only
Factory Use Only
51