Connecting The Fm Antenna - Samsung HT-C7550W User Manual

Connections
Wireless Network
You can connect to the network with a Wireless IP sharer.
1. A wireless AP/IP router is required to make a wireless network connection. Connect the wireless
LAN adapter to the Wireless LAN Adapter on the rear panel of the product.
- This unit is compatible with the supplied Wireless LAN Adapter.
- You can also use the wireless network by connecting the Wireless LAN Adapter Gender to the
Wireless LAN Adapter.
2. Set the network options. (See page 39)
Broadband
service
Wireless IP sharer
PC
Networking with PC for
AllShare function
(See pages 62~63)
✎
NOTE

You must use a wireless IP sharer that supports IEEE 802.11 a/b/g/n. (n is recommended for stable operation of the
wireless network.)

Wireless LAN, in its nature, may cause interference, depending on the use condition (AP performance, distance, obstacle,
interference by other radio devices, etc).

Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.

When applying the security key for the AP (wireless IP sharer), only the following is supported.
1) Authentication Mode : WEP, WPAPSK, WPA2PSK
2) Encryption Type : WEP, AES

For the AllShare function, a PC must be connected in the network as shown in the fi gure.
iPod
28
English
Connecting to the Network

Connecting the FM Antenna

FM Antenna (supplied)
OR
Wireless LAN Adapter
1. Connect the FM antenna supplied to the FM
Antenna Jack.
2. Slowly move the antenna wire around until
you fi nd a location where reception is good,
then fasten it to a wall or other rigid surface.
✎
NOTE

This product does not receive AM broadcasts.
iPod