Connecting The Fm Antenna - Samsung HT-D7500W User Manual

5.1ch blu-ray home entertainment system

Hide thumbs

Table Of Contents

Table of Contents

CAUTION

Do not let children play with or near the speakers. They could get hurt if a speaker falls.

When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct.

Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands

or alien substances into the duct (hole) of the subwoofer speaker.

Do not hang the subwoofer on the wall through the duct (hole).

Do not insert any other card except the TX card dedicated to the product.

If you insert a different TX card, you can damage the product and may not be able to remove the

card easily.

Do not insert the TX card upside down or in the reverse direction.

Insert the TX card when the product is turned off. Inserting the card when it is turned on may

cause a problem.

The wireless receiving antenna is built into the wireless receiver module. Keep it away from water

and moisture.

For optimal listening performance, make sure that the area around the wireless receiver module

location is clear of any obstructions.

If no sound is heard from the wireless surround speakers, switch the mode to Dolby Pro

Logic II.

In 2-CH mode, you will hear no sound from the wireless surround speakers.

✎

NOTE

If you place a speaker near your TV set, the screen colour may be distorted because of the magnetic

fi eld.

Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is

too close to the product, sound from the speakers may be disrupted because of interference.

If you use a device such as a microwave oven, wireless LAN Card, or any other device that uses

the 2.4/5.8GHz frequencies near the product, sound from the speakers may be disrupted

because of interference.

The maximum transmission distance from the product to the wireless receiver module is about 33

feet (10m), but may vary depending on your operating environment. If a steel-concrete wall or

metallic wall is between the product and the wireless receiver module, the system may not operate

at all, because the radio wave cannot penetrate metal.

If the product doesn't make a wireless connection, you need to run an ID Set between the

product and wireless receiver module. With the product turned off, press "0""1""3""5" on

the remote control. Turn on the wireless receiver module. Then, press and hold the "ID SET"

button on the back of the wireless receiver module for 5 seconds, and then turn the product on.

FM Antenna (supplied)

FM ANT