Hyundai 2020 SANTA FE Manual page 129

TMa CAN-E 3A(~114).qxp 5/21/2019
Programming HomeLink
Please note the following:
• When programming a garage door
opener, it is advised to park the
vehicle outside of the garage.
• It is recommended that a new bat-
tery be placed in the hand-held
transmitter of the device being pro-
grammed to HomeLink
training and accurate transmission
of the radio-frequency signal.
• Some vehicles may require the
ignition switch to be placed in the
ACC (or "Accessories") position for
programming and/or operation of
HomeLink ® .
• In the event that there are still pro-
gramming difficulties or questions
after following the programming
steps listed below,
HomeLink ® at: www.homelink.com,
www.youtube.com/HomeLinkGentex
or by calling 1-800-355-3515.
11:11 AM Page 37
Programming
®
To program most devices, follow
these instructions:
®
for quicker
1. Press and release (1), (2) or (3)
button.
• If the indicator (4) is turned ON in
Orange, go to Step 3) since it is a
contact
new programming.
• If the indicator (4) is continuously
turned ON or flashes in Green
rapidly several times, go to Step
2) since it is a programmed but-
ton.
2. Press and hold the button you
wish to program for approximately
15-25 seconds until the LED flash-
es in Orange for several times.
3. Hold the Garage Door Opener
Original Transmitter (OT) near the
HomeLink Mirror.
OTMA048468C
4. Press the Original Transmitter (OT)
button until the indicator (4) is
turned continuously ON or flashes
in Green for approximately 10 sec-
onds and it indicates the program-
ing is completed.
i
Information
• Some garage door openers require
to press the programmed button on
the mirror up to three times right
after the programming is just com-
pleted to operate the garage door.
3
OTMA048469C
3-37