Zanussi ZCG51011WA User Manual page 19

Table of Contents

Advertisement

Available languages

Available languages

5. Replace the rating plate (it is near the gas
supply pipe) with the one for the new type
of gas supply.
You can find this plate in the bag
supplied with the appliance.
If the supply gas pressure is not constant or it is
different from the necessary pressure, install an
applicable pressure adjuster on the gas supply
pipe.
Adjustment of minimum level at the hob
burner
1. Remove the knob for the hob.
If there is no access to the bypass screw
dismount the control panel before adjustment
start.
2. Adjust the bypass screw (A) with a thin and
flat screwdriver.
Positions of the bypass screw (A) depends on
model.
Change from natural gas to liquid gas
1. Fully tighten the bypass screw.
2. Put the knob back.
Change form liquid gas to natural gas
1. Unscrew approximately one turn the bypass
screw position (A).
2. Put the knob back.
3. Light the burner.
Refer to "Hob - Daily use" chapter.
4. Turn the knob on the minimum position.
5. Remove the knob again.
6. Screw on slowly the bypass screw till the
flame becomes minimum and stable.
www.zanussi.com
A
7. Put the knob back.
8. Set the maximum gas flow position on the
oven knob and let the oven heat for at least
10 minutes.
9. Quickly turn the knob for the oven functions
from maximum to the minimum gas glow
position.
Control the flame. Make sure the flame does not
go out when you turn the knob to the minimum
gas flow position. There must be a small regular
flame on the oven burner crown. If the flame
goes out adjust the oven burner again.
Oven injector replacement
1. Remove the bottom plate of the oven cavity
(A) to get access to the oven burner (B).
B
A
2. Release the screw (C), which keep the
burner in position.
C
3. Carefully move the burner off the injector
support (D).
D
E
4. Slowly move it to the left side. Make sure
that the burner bush stays on the burner
mouthpiece. Do not apply force to the wire
of the thermocouple conductor (E).
5. Release the burner injector (D) with a 7 mm
socket spanner and replace it with a
different one.
19

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents