Safety; General Safety Information; Safety Standards - 3ctest EDS 20H User Manual

EDS 20H Hand-held Electrostatic Discharge

1 Safety

1.1 General Safety Information

This equipment should only be operated after carefully reading the user manual.
The earth connection of the ESD Simulator must be connected to a good earth.
If trigger is pressed without connection to earth, electrical shock may occur!
Dangerous mains voltage or high voltages are present inside EDS 20H.
Do not open any part of EDS 20H as it contains no user replaceable parts. This
does not apply to the cover used for replacement of RC module.
EDS 20H should only be maintained by trained personnel.
People with heart pacemakers must not be in the vicinity of the system, when it is
in operation.
Do not switch on or operate the EDS 20H if an explosion hazard exists.
The system should be operated in dry room. If condensation is visible the unit
should be dried before operating.
Never touch the equipment under test when EDS 20H is operating.
If any part of the EDS 20H is damaged or it is possible that damage has occurred,
for example during transportation, do not switch on the unit.
This user manual is an integral part of the system. Suzhou 3ctest Electronic Co.,
ltd. and its sales partners refuse to accept any responsibility for consequential or
direct damage to persons and/or goods due to none observation of instructions
contained herein or due to incorrect use of the EDS 20H.

1.2 Safety Standards

EDS 20H fulfils the requirements of IEC 61010-1。
Web： www.3ctest.cn
Simulator---User Manual
1 /28
3CTEST 20151021 V1.1
E-mail info@3ctest.cn