Check List For Troubleshooting - tams elektronik WIB-31 Manual

English
Applications /
Examples
Switching the
LEDs
Dim switch
Fluorescent tube
simulation
Random light
Orientation light
AUX1
AUX2
AUX3
Applications /
Examples
Switching the
LEDs
Dim switch
Fluorescent tube
simulation
Random light
Orientation light
AUX1
AUX2
AUX3

10. Check list for troubleshooting


Parts are getting too hot and/or start to smoke.
Disconnect the system from the mains immediately!
!
Possible cause: one or more connections are soldered incorrectly. à
Check the connections.
Possible cause: Short circuit. The module is connected to locomotive
or carriage ground. à Check the connections. A short circuit can
result in irreparable damage.

The lighting goes on and off when the speed levels are turned up or
the lighting cannot be switched on or off.
Possible cause: The speed mode of the decoder and the digital
control unit do not correspond. Example: The central is set to the
mode 28 speed levels, but the decoder to the mode 14 speed levels.
à Change the speed mode at the central and / or at the decoder.

The decoder does not react in analogue mode.
Possible cause: The analogue mode is switched off. à Alter the
value for CV #29.
Page 40
Preset 1
Control units with few
function keys
st
F1: 1 half of LEDs
nd
F2: 2 half of LEDs
to be switched with F4
off
for AUX3
to be switched with F3
F0, on at backwards
motion
F0, on at forwards
motion
Random light,
not to be switched
Preset 3
Connection of couplings
to AUX1/3
st
F1: 1 half of LEDs
nd
F2: 2 half of LEDs
to be switched with F6
on
---
to be switched with F5
to be switched with F3,
Kick function
F0, on at forwards
motion
to be switched with F4,
Kick funktion
WIB-31 | WIB-32 | WIB-33
Preset 2
Control units with few
function keys
F1: all LEDs
to be switched with F3
off
---
to be switched with F2
F0, on at backwards
motion
F0, on at forwards
motion
to be switched with F4