Table Of Contents - tams elektronik WIB-31 Manual

WIB-31 | WIB-32 | WIB-33 English

Table of contents

1. Getting started .........................................................................24
2. Safety instructions.....................................................................25
3. Safe and correct soldering.........................................................26
4. Operation overview...................................................................27
5. Technical specifications..............................................................30
6. Mounting the carriage lighting....................................................31
7. Programming the function decoder ............................................33
8. Configuration variables and registers..........................................34
9. Presets.....................................................................................39
10. Check list for troubleshooting.....................................................40
11. Guarantee bond........................................................................42
12. EU declaration of conformity.....................................................42
13. Declarations conforming to the WEEE directive...........................42
Shortening the PCB (Fig. 1)............................................................... I
Connecting the power supply (Fig. 2)................................................ I
Parallel operation from one power supply (Fig. 3)............................... I
Circuit Diagram (Fig. 4)..................................................................... I
Overall view (Fig. 5)........................................................................ II
Connecting bridging capacitors (Fig. 6)............................................. II
Connecting a light dependent resistor (Fig. 7)................................... II
Connecting LEDs for the back lighting (Fig. 8)................................... II
Connecting supplemental loads (Fig. 9)............................................ II
Connecting section 2 of the PCB to a decoder (Fig. 10)...................... II
Connecting section 2 of the PCB to an analogue power supply (Fig. 11).... II
(Pages I to II in the centre of this handbook are removeable.)
®
Remark: RailCom is the registered trademark of the Lenz Elektronik
GmbH, Hüttenbergstraße 29, D-35398 Gießen. To increase the text´s
readability we have refrained from refering to this point in each
instance.
The asterisks **
This manual mentions the following companies:
Gebr. MÄRKLIN** & Cie. GmbH | Postfach 8 60 | D-73008 Göppingen
Page 23