Configuration Variables And Registers - tams elektronik WIB-31 Manual

English
Programming with the Central Station and the Mobile Station
With the Central Station or the Mobile Station of Märklin* you can
program the registers, but the value to be set is limited to 80. Select
the article no. 29750 from the locomotive database and program the
decoder as described for this article in the Central Station´s or Mobile
Station´s manual.
Programming with the CV-Navi
Instead of programming the configuration variables or registers of the
decoder using the digital central unit, you can use the free software CV-
Navi. You will find the free download under:
www.tams-online.de

8. Configuration variables and registers

The following list shows all configuration variables (for the DCC format)
and registers (for the Motorola format), that can be set for the
integrated function decoder.
In the list you will find in the column "CV-no." the numbers of the
configuration values for programming in DCC format and in the column
"Reg.-no." the numbers of the registers for programming in Motorola
format. The defaults are those values set in the state of delivery and
after a reset.
If you do not want to program all configuration variables or registers
individually you can fall back on different presets (see CV#130 and
section 9.)
Please note: With variables destined to set several parameters, the input
value has to be calculated by adding the numerical values assigned to the
desired parameters.
Setting the address
Name of CVs /
Registers
Basic address
Tip: If a value higher than 127 is set for the basic address and the use of extended addresses
in CV#29 is set to off, the decoder does not react to signals in DCC format!
Extended
address
Consistadresse 19
2nd Motorola
address
Page 34
CV- Reg. Input value
no. no. (Default)
1 01 1 ... 255
(3)
17 06 192 ... 255
(192)
18 07 0 ... 255
(255)
08 1 ... 127
(0)
114 39 1 ... 255
(4)
WIB-31 | WIB-32 | WIB-33
Remarks and Tips
Settings
Range of values in
DCC format: 1 ... 127
MM format: 1 ... 255
Only for DCC format. Most
central units permit entering
extended addresses directly.
The CVs # 17, 18 and 29 are
set automatically to the
proper values.
nd
= 2 adress
In DCC format only!
= Address needed to switch
additional functions in
Motorola format. The
function keys F5 to F8 are
reached via the function
keys F1 to F4, the function
key F9 via the function key
F0.