Table of Contents
Advertisement
English
10. Check list for troubleshooting
Parts are getting too hot and/or start to smoke.
Disconnect the system from the mains immediately!
!
Possible cause: one or more connections are soldered incorrectly. à
Check the connections.
Possible cause: Short circuit. The module is connected to locomotive
or carriage ground. à Check the connections. A short circuit can
result in irreparable damage.
The lighting goes on and off when the speed levels are turned up or
the lighting cannot be switched on or off.
Possible cause: The speed mode of the decoder and the digital
control unit do not correspond. Example: The central is set to the
mode 28 speed levels, but the decoder to the mode 14 speed levels.
à Change the speed mode at the central and / or at the decoder.
The decoder does not react in analogue mode.
Possible cause: The analogue mode is switched off. à Alter the
value for CV #29.
After programming the decoder the functions do not match your
ideas.
Possible cause: The set values for the CV are inconsistent.
à Perform a decoder reset and first test the decoder with the
default values. Program the decoder anew.
The LEDs do not light and / or the accessories connected to the
outputs do not have any function.
Possible cause: The connection to the power supply has been
interrupted. à Check the connection of the module.
Possible cause: The dim switch is activated and the limit value is set
the wrong way.
à Check the settings in CV#112, CV#113 and CV#115.
You cannot switch an output.
Possible cause: The dim switch is activated and has switched off the
LEDs and the outputs automatically. à Switch off the dim switch.
Possible cause: In CV#115 there are other address ranges defined to
switch the outputs than presumed. à Check the settings in CV#115.
The lighting and / or other accessories do not correspond to the
direction of travel.
Possible cause: The direction of travel is falsely defined in CV#29.
Possible cause: The settings in CV#33, #34 and / or ##53 - 58 are
false. à Check the settings.
Hotline
If problems with your module occur, our hotline is pleased to help you
(mail address on the last page).
Repairs
You can send in a defective module for repair (address on the last
page). In case of guarantee the repair is free of charge for you. With
damages not covered by guarantee, the maximum fee for the repair is
50 % of the sales price according to our valid price list. We reserve the
right to reject the repairing of a module when the repair is impossible
for technical or economic reasons.
Please do not send in modules for repair charged to us. In case of
warranty we will reimburse the forwarding expenses up to the flat rate
we charge according to our valid price list for the delivery of the
product. With repairs not covered by guarantee you have to bear the
expenses for sending back and forth.
Page 20
WIB-33.2
Advertisement
Table of Contents
