Korenix JetBox 8100 Quick Installation Manual page 3

Install Compact Flash or 2.5" HDD
If you are installing Compact Flash modules you need to remove a front side cover.
(Please see the spots circled.)
Note: The Compact Flash socket supports 3.3V Compact Flash and Micro Drives. The JP1 is
used to select master/slave device of this socket and default is slave (close). Be sure to avoid
the same master/slave setting with which connects to IDE connector, if you use CF and IDE
hard disk simultaneous.
If you are installing hardware option, you can remove the rear panel and bottom cover. The
following figure will guide you how to install 2.5" HDD inside the JetBox 8100 and how to
install the JetBox 8100 fixers.
Note: Use caution when handling the hard disk to prevent damage to IDE connector as you
insert hard disk.
Be careful with pin orientation when installing connectors and the cables. A wrong connection
can easily destroy your hard disk.CN3 is used to connect a 2.5" HDD with included 44-pin flat
cable.
JetBox 8100
PS/2
2-pin
44-pin 4 2.5" HD
3
LAN
COM1
Industrial Communication Computer
Reset
ON OFF
ACT LINK
PWR HDD
JetBox 8100
44.2(REF)
VAG
120(REF)
9
COM2
12~24V DC
Power input
:
44.2(W) x 123(H) x 120(D)mm
:
0.7kg
:
o o
-15 C ~ 70 C, 5 to 95% RH (
:
: 12VDC ~ 24 VDC
:
)