Tuning Your Television For The Dvd-Vcr - Samsung SV-DVD440 Instruction Manual

Tuning Your Television for the DVD-VCR

GB
STANDBY/ON
2
4
14
You must tune your television for the DVD-VCR only if you are
not using a Scart cable
OPEN/CLOSE
1
2
3
4
5
6
7
8
To view pictures from your DVD-VCR when a Scart
cable is used, the television must be set to the
audio/video mode (AV).
Switch on the television.
Switch on the DVD-VCR by pressing STANDBY/ON on the front
of the DVD-VCR or STANDBY/ON on the remote control.
Select a programme position on the television to be reserved for
use with your DVD-VCR.
Insert the video cassette in the DVD-VCR. Check that the
DVD-VCR starts reading the cassette; if not, press
Start a scan on your television or set the television to UHF
channel 60.
Fine tune the television until the pictures and sound are obtained
clearly.
If you cannot find the pictures and sound, or there is interference
from nearby channels, it may be necessary to change the setting
of the DVD-VCR output channel (see Setting the DVD-VCR
Output Channel on page 23 and Problems and Solutions on
page 69).
When the picture and sound are perfectly clear, store this
channel at the desired programme position on the television.
Result: That programme is now reserved for use with your
DVD-VCR.
❿ II
button .