Tuning Your Television For The Dvd-Vcr - Samsung SV-DVD50 Instruction Manual

Tuning Your Television for the DVD-VCR

You must tune your television for the DVD-VCR only if you are not
using a Scart cable
GB
STANDBY/ON OPEN/CLOSE
2
1
2
3
4
5
4
6
7
8
16
To view pictures from your DVD-VCR when a Scart cable
is used, the television must be set to the audio/video
mode (AV).
Switch on the television.
Switch on the DVD-VCR by pressing STANDBY/ON on the front of
the DVD-VCR or STANDBY/ON on the remote control.
Select a programme position on the television to be reserved for
use with your DVD-VCR.
Insert the video cassette in the DVD-VCR. Check that the
DVD-VCR starts reading the cassette; if not, press ❿ II
button.
Start a scan on your television or set the television to UHF
channel 36.
Fine tune the television until the pictures and sound are obtained
clearly.
If you cannot find the pictures and sound, or there is interference
from nearby channels, it may be necessary to change the setting
of the DVD-VCR output channel (see Setting the DVD-VCR
Output Channel on page 25 and Problems and Solutions on page
68).
When the picture and sound are perfectly clear, store this channel
at the desired programme position on the television.
Result: That programme is now reserved for use with your
DVD-VCR.
Deck Control Keys
The DVD-VCR uses one set of controls to operate both decks. The
following keys are helpful in successfully controlling each deck.
1
STANDBY/ON Button
Press the STANDBY/ON button on the remote control or front
panel to turn on the DVD-VCR.
2
DVD Button
Press the DVD button on the remote control when you want to
control the DVD deck.
The DVD indicator will light on the Front Panel Display to show
that the DVD deck is selected.
3
VCR Button
Press the VCR button on remote control when you want to control
the VCR deck.
The VCR indicator will light on the Front Panel Display to show
that VHS deck is selected.
4 INPUT SEL. BUTTON
Press the INPUT SEL. button repeatedly to cycle through all of
your input sources, including the Tuner (PR##), AV1 (rear AV
input), AV2 (rear AV input), AUX (front AV input).
• It is only available when VCR deck is selected.
Before using the VCR operation of 21~45 pages, press
the VCR button on the remote control to select VCR
mode.
Before using the DVD operation of 47~66 pages, press
the DVD button on the remote control to select and
watch DVD.
GB
STANDBY/ON
STANDBY/ON
1
1
2 3
4
17