Table of Contents
Advertisement
Protecting a Recorded Cassette
GB
Video cassettes have a safety tab to prevent accidental erasure.
When this tab has been removed, you cannot record on the tape.
1
Recording a Programme Immediately
Before recording a programme, you must have preset the corres-
ponding station (unless you are recording via an external video
source). If you have not done so, refer to pages 20 and 21.
4
4
6
5
7
26
1
If you wish to protect a cassette, break off the tab using a small
screwdriver.
2
To re-record over a protected cassette (safety tab broken), cover
the hole with adhesive tape.
1
Switch on the television.
2
To monitor the programme being recorded, select the television
channel reserved for use with your DVD-VCR (or the AV input if
used).
3
Insert the cassette on which the programme is to be recorded,
with the window visible and the safety tab intact or the opening
covered with adhesive tape.
Result:
The DVD-VCR is switched on automatically.
4
Select:
The station to be recorded using the PROG(
or
The AV1, AV2 or AUX source using the TV VIEW button for a
satellite tuner or external video source
Result:
The station number is displayed and the programme
can be seen on the television.
5
Select the recording speed by pressing the SPEED button as
many times as required (see page 24).
6
Hold REC ( I
) down for a while to start recording.
Result:
The record indicator appears on the television and DVD-
VCR display. An index is recorded on the tape (see
page 38).
7
To stop recording, press
once.
If your DVD-VCR ejects the cassette when you start
recording, check to make sure that the cassette's
safety tab is intact or that the opening (created by a
broken safety tab) is covered with adhesive tape.
If you reach the end of the tape while recording, the
cassette rewinds automatically.
Recording a Programme with Automatic Stop
This function enables you to record up to nine hours (LP) of
programmes.
Your DVD-VCR stops automatically after the requested length of
time.
1
Switch on the television.
2
To monitor the programme being recorded, select the television
channel reserved for use with your DVD-VCR (or the AV input if
used).
3
Insert the cassette on which the programme is to be recorded,
with the window visible and the safety tab intact or the opening
covered with adhesive tape.
Result:
The DVD-VCR is switched on automatically.
4
Select:
The station to be recorded using the PROG(
or
The AV1, AV2 or AUX source using the TV VIEW button for a
satellite tuner or external video source
Result:
The channel number is displayed and the programme
can be seen on the television.
5
Select the recording speed by pressing the SPEED button as
many times as required (see page 24).
6
Hold the REC button ( I
Result:
The record indicator appears on the television screen
and DVD-VCR display. An index is recorded on the
tape (see page 38).
7
Press the REC button ( I
recording time in:
or
) buttons
30-minute intervals up to four hours
1-hour intervals up to nine hours (LP)
Result:
The length is displayed on the television displays. The
selected programme is recorded for the length of time
requested. At the end of that time, the DVD-VCR stops
recording automatically.
8
If you wish to cancel the recording before the end, press
STANDBY/ON.
If the end of the tape is reached while recording:
The recording stops
or
) buttons
) down for a while to start recording.
) several times to increase the
SET LENGTH :
GB
3
4
4
6
5
LENGTH 2:30
PRESS REC
27
Hide quick links:
Advertisement
Table of Contents
