Operating Instructions For The End User - Neptun Compact 950 Manual

GSA 950-1200 ABS 3sprachig_A4 07.03.19 08:32 Seite 11

Operating instructions for the end user

Turn on/off the pump (fig. 13)
By pressing the PN-button pos.1, the pneumatic switch is actuated and the pump is in opera-
tion. Press again to turn off the pump.
stream direction and beam control (fig. 13)
The stream direction can be set by the all-round swiveling nozzle pos. 2. By rotating the nozzle
you make the water jet stronger or weaker.
air control and massage (fig. 13)
By rotating the ring pos. 3 which is mounted on the nozzle, the air supply gets weaker or stron-
ger.
swimming against the countercurrent
Swivel the nozzle that the water layer directly below the water surface is placed in strong current.
Use of the massage equipment (fig. 14)
Before installing or removing, the countercurrent system must be switched off. To attach the
massage unit, pull back the sliding sleeve pos. 5 and push the hose coupling in the nozzle pos.
2. Then press the sliding sleeve against the nozzle and pull the hose back pos.6. The hose coup-
ling is locked. To uncouple, press the hose pos. 6 against the sliding sleeve pos. 5. Take the sli-
ding sleeve and pull it out.
Attention:
Do not take the massage equipment closer than 30 cm to your body, you get the optimal
massage effect at full flow capacity and suitable distance.
Wintering
Drain the water to below the nozzle block. The pump must be emptied with the help of the drai-
ning screw on the front. Only after the end of the danger of frost the drain plug can be screwed
again.
11
Betriebsanleitung GSA Compact 950/1200 ABS V.20190307