Table of Contents
Advertisement
Safety instructions and measures
1.3 Notes on possible property damage
NOTICE
!
Risk of the process medium being contaminated through the use of unsuitable lubri-
cants and/or contaminated tools and components.
Î Keep the regulator and the tools used free from solvents and grease.
Î Make sure that only suitable lubricants are used.
Incorrect control due to the formation of ice on the regulator.
Medium temperatures below 0 °C may cause ice to form on the regulator, depending
on the air humidity. This may affect, in particular, the functioning of the plug or control
thermostat stem guide.
Î Prevent the formation of ice by taking appropriate precautions (e.g. enclosure,
trace heater etc.). The plant operator is responsible for selecting and implementing
appropriate precautions. See the 'Installation' section.
Risk of irreparable regulator damage caused by the regulator components being
taken apart.
The control thermostat is an inseparable hydraulic unit consisting of a control thermo-
stat, capillary tube and temperature sensor. If these components are dismantled (e.g.
removal of the capillary tube), the regulator will be irreparably damaged and will no
longer be able to fulfill its control task.
Î Do not dismantle the regulator.
Î Only perform allowed activities on the regulator.
Î Contact SAMSON's After-sales Service before replacing spare parts.
Note
SAMSON's After-sales Service can support you concerning lubricant, tightening torques
and tools approved by SAMSON.
1-8
EB 2172 EN
Advertisement
Table of Contents
