Epson SC-T3100M Series User Manual page 9

SC-T3100M Series/SC-T5100 Series/SC-T3100 Series/SC-T5100N Series/SC-T3100N Series/SC-T2100 Series User's Guide
E
Paper stacker (for plain paper)
Attach to the front of the printer as shown when printing multiple sheets of plain paper continuously from the
auto sheet feeder. Printed paper stacks up in this tray after it is ejected. Remove this when printing on roll
paper or cut sheets (1 sheet).
The paper stacker is not included with the SC-T2100 Series. It is available as an optional extra.
"Installing and removing the paper stacker (for plain paper)" on page 35
U
F
B1 width paper support (SC-T5100 Series/SC-T5100N Series only)
For roll paper or cut sheet (1 sheet) equivalent to B1 width (718 to 738 mm) only, raise the B1 width paper
support before printing to prevent scuffing and soiling of the print surface
"Loading Roll Paper" on page 29
U
"Loading Cut Sheet(1 sheet)" on page 39
U
G
Edge guide
Align these with the left and right edges of the paper loaded in the auto sheet feeder. Prevents paper from being
fed at an angle.
H
Auto Sheet Feeder
You can load multiple cut sheets of A4 to A3 paper. The loaded paper is fed automatically allowing you to print
continuously.
"Loading paper into the auto sheet feeder" on page 35
U
I
Cut sheet cover
Open when using the auto sheet feeder or when loading cut sheet paper.
"Loading Cut Sheet(1 sheet)" on page 39
U
When loading roll paper, open this cover and then open the roll paper cover.
To prevent dust from accumulating inside the printer, close the auto sheet feeder when it is not in use or when
you are not loading cut sheet paper.
J
Front cover
Open this cover when replacing ink cartridges or clearing a paper jam.
Introduction
9