Epson SC-T3100M Series User Manual page 141

SC-T3100M Series/SC-T5100 Series/SC-T3100 Series/SC-T5100N Series/SC-T3100N Series/SC-T2100 Series User's Guide
Settings item
Advanced Media Setting
Platen Gap
Top/Bottom Mar-
gins
Back Tension
Drying Time
Drying Time per
Pass
Drying Time per
Page
Auto Cut
Restore Default
Printing Language
Using the Menu
Settings value
1.6
2.1
2.6
*
Standard
Top 3 mm/Bottom 3 mm
Top 15 mm/Bottom 15 mm
Top 45 mm/Bottom 15 mm
*
Auto
Standard
High
Extra High
*
0.0 to 10.0 seconds (0.0 )
*
0.0 to 60 minutes (0.0 )
*
On
Off
Explanation
This is the Platen Gap (distance between print head and paper) for
the paper selected in Change Reference Paper, so it does not
normally need to be changed. Change this to a setting that will
widen the gap (a higher value) if print results are smeared.
Setting this to Standard will set the top/bottom margins as follows
depending on the printer driver print targets.
❏
CAD Line Drawing: 3 mm/3 mm
❏
Others: 30 mm/30 mm
Left and right margins will remain at 3 mm regardless of settings. If
there is any soiling on the top section of the print results, increase
the top margin.
"Printable area" on page 214
U
If there is any wrinkling on the paper during printing, select High
or Extra High.
Select the time the print head pauses to allow drying after each
pass. Choose from values between 0.0 and 10.0 seconds
Depending on the paper type, the ink may take a while to dry. If
the ink blurs on the paper, set a longer time for drying the ink.
Increasing the drying time increases the time needed to print.
Specify how long the printer pauses to allow the ink to dry after
printing each page; choose from values between 0 and 60 minutes.
Depending on the ink density or paper type, the ink may take a
while to dry. If the ink blurs on the paper, set a longer time for
drying the ink. The longer the drying time, the more time required
for printing.
Select whether to automatically cut (On) or not cut (Off) using the
built-in cutter as each page is printed on roll paper. Set On to
automatically cut the edge if it is not a horizontal cut when paper is
loaded.
The setting selected with the printer driver takes priority when the
printer driver is used.
"Cutting the Roll Paper" on page 31
U
Restore the selected Custom Paper settings to default settings.
141