Re-Installing The Rear Panel; Indicator Setup - Cardinal 2XX-EIP Installation Manual

RE-INSTALLING THE REAR PANEL

When the installation is complete:
1. Remove the excess cable from the indicator enclosure.
2. Make certain no cables or wires are exposed between the main housing and rear panel
and then place the rear panel onto the main housing.
3. Secure with the acorn nuts removed earlier. Follow a diagonal pattern when tightening
the acorn nuts.
4. Tighten the gland connector nut to seal the cable. Do not over-tighten the connector but
make certain they are snug. DO NOT USE TOOLS! Finger-tighten only! Insure any
unused gland connectors are plugged.
No special setup is required on the indicator.
On an EtherNet/IP network, each node must be assigned its own unique TCP/IP address. The
2XX-EIP EtherNet IP interface card IP address is set using the Anybus IPconfig Tool utility
provided on the 2XX-EIP Config File CD (8200-M533-O1).
8200-M554-O1 x 2XX-EIP

INDICATOR SETUP

TCP/IP ADDRESS SETUP
Page 4