Table of Contents
Advertisement
RE-INSTALLING THE REAR PANEL
When the installation is complete:
1. Remove the excess cable from the indicator enclosure.
2. Make certain no cables or wires are exposed between the main housing and rear panel and
then place the rear panel onto the main housing.
3. Secure the panel to the main housing with the acorn nuts (12 on the 205/210, 14 on the
225) removed earlier.
4. Tighten the gland connector nut to seal the cable.
Do not over-tighten the connector but make certain they are snug.
DO NOT USE TOOLS! Finger-tighten only!
Make sure any unused gland connectors are plugged.
5. If required, install the lead and wire calibration seal.
With the 2XX-EIP option card installed, a sub-menu
(Key Lock Out Function). The
change the output weight byte order.
NOTE: The prompt will display as
using the ENTER key to advance through the setup prompts.
(Output Weight Byte Order)
Press the ENTER key to show the current setting. If the setting displayed is acceptable,
press the ENTER key again to save it. Otherwise, using the numeric keys (or the arrow keys
on the 205) enter the new setting, then press the ENTER key to save it. Allowable values
are:
Default setting.
With the indicator ON, press the SHIFT key and then press the Navigation ENTER key (red
square key in the center of the Navigation arrows). The display will change to show the
SETUP/REVIEW MENU.
1.ENTER CALIBRATION AND SETUP
2.VIEW AUDIT TRAIL COUNTERS
3.CALIBRATE SCALE 1
Enter Selection: 1
Press the ENTER key, and then press the NEXT Navigation arrow until SETUP MENU #3 is
displayed.
8200-M554-O1 Rev C 2XX-EIP Installation and Setup Manual
205/210 INDICATOR SETUP
sub-menu contains the setup selection to
when using the CAL switch and
225 INDICATOR SETUP
SETUP/REVIEW MENU
8.SCALE ID=00
9.DEL CUSTOM TICKET
10.PRINT SETUP
^
EXIT
(Option) has been placed after
when
5
Advertisement
Table of Contents
