Wieland AGC Micro Plus Operating Instructions Manual page 49

6 6 . . P P o o s s s s i i b b l l e e f f a a u u l l t t s s a a n n d d t t r r o o u u b b l l e e s s h h o o o o t t i i n n g g
Error messages
In the event of a fault or error, the unit displays an error
code in the Position display.
These error codes are described in detail below
(see also the inside of the front plate of the unit).
F0: No parts contacted / no gold electrolyte present.
➠
Rectify the fault, then press the Start/Stop button
to activate the process.
F1: Bath temperature too low
➠
If the bath temperature sinks too low during
electroforming (e.g. in the case of defective
heater or defective internal temperature sensor),
the process is interrupted. In this case, contact
WIELAND EDELMETALLE or your authorized
dealer.
F2: Temperature sensor not correctly contacted or
heater defective.
➠
First make sure that the anode with the tempe-
rature sensor is correctly inserted and clicked
into place. If this does not rectify the fault, the
temperature sensor or the heater is defective. In
this case, contact WIELAND EDELMETALLE or
your authorized dealer.
F3: Agitator motor defective
➠
In this case, contact WIELAND EDELMETALLE or
your authorized dealer.
F4: Electroforming head not lowered
➠
Push the electroforming head onto the beaker,
make the contacts and press the Start/Stop key
to activate the process.
21