Table of Contents
Advertisement
check the circuit. Be aware that other nearby
circuits can still be powered.
Do not open access panels or approach
electrical components while voltage is applied
unless measurements are impossible
otherwise. When hazardous live parts are
exposed use personal protective equipment to
prevent risk of electric shock. Use suitable
protective gloves, fire resistant clothes and
face protection when working with live
conductors. Keep fingers behind protective
barriers.
The current and voltage logger is rated CAT III
and must always be connected behind the
installation's circuit breakers.
Do not use the device in environments where
vibration or shocks are likely to disrupt the
function or compromise the safety of the
device.
Do not wear loose clothes or jewelry like
chains or bracelets which could make contact
with electrical components.
Allow the installation environment to cool or
heat to acceptable temperatures before
attempting to install a device sensor.
Always ensure any pressure within a
compressed air system is safely vented to
atmosphere before attempting to remove or
install a device sensor, never assume the
compressed air system is vented but always
check the air gauge. Be aware that other
nearby parts can still be hot, cold or
pressurized.
The device should be installed in such a
location as to allow operational and
maintenance access to the installation without
obstruction or hazard and to allow clear
visibility of indicators at all times.
Section 1.3: Operation
Correct operation of the device may only be
checked by trained personnel according to
safe practices equipped with appropriate
protection against hazards.
The device must only be operated at the
ratings: supply voltage, frequency, pressure,
temperature, altitude, humidity and
environmental rating for which it is designed.
Do not operate the device without battery
door, enclosure open or covers removed.
The device's batteries are monitored,
replacing the batteries during operation is not
necessary.
Do not operate the device in high humidity
environments or with wet hands
Do not direct access panels or
expose electrical components while
device is operating.
Section 1.4: Maintenance
Maintenance must only be carried out by
competent personnel under qualified
supervision.
If replacement parts are required use only
genuine parts from the original equipment
manufacturer.
Before competent personnel under qualified
supervision remove any access panels or
carry out work on the device, isolate from the
source of supply power using relevant and
local safe isolation procedures.
Ensure that all instructions concerning
operation and maintenance are strictly
followed and that the complete device, with all
accessories and safety devices, is kept in
good working order.
The accuracy of sensor devices must be
checked on a regular basis. They must be
renewed when acceptable tolerances are
exceeded. Always ensure any pressure within
a compressed air system is safely vented to
atmosphere before attempting to remove or
install a sensor device.
The device must only be cleaned with a damp
cloth, using mild detergents if necessary.
Avoid the use of any substances containing
corrosive acids or alkalis. Remove all input
signals before cleaning the device.
Do not paint the control facia or obscure any
indications, controls, instructions or warnings
Section 1.5: Batteries
Do not use other types of batteries than those
originally supplied.
Use supplied batteries only in device as
intended. Pay attention on the polarity when
fitting batteries.
Keep batteries out of reach from children and
Page 5
Advertisement
Table of Contents
