Version Revision; Eq Lte Equipment; Eq Lte Base Station; Physical - Quincy EQ LTE 2014900479 Technical Manual

3.0 Version revisions
Use the base station graphical user interface
and EQ LTE™ base station operating
procedures to maintain software in both the
EQ LTE™ base station and EQ LTE™ data
loggers.
Audit configuration and logger data are
unaffected by the software update process.
As such, a base station software update can
be performed at any time.
Updating of loggers should not be performed
whilst the data logger is in operation (i.e.
installed and logging data). Complete any
logging activity and transfer any logged data
from data loggers to base station and to the
cloud computing environment before
performing a data logger software update
4.0 EQ LTE™ equipment
4.1 EQ LTE™ base station

4.1.1 Physical

Front elevation
Back elevation
Side elevation
Side elevation
Note:
A tamper resistant label providing device ID,
serial number and original equipment
manufacturer bar code data is located on the
back elevation of the base station

4.1.2 Preparing for first use

Each EQ LTE™ base station is supplied with a
power supply and a variety of 'domestic' power
supply heads.
You will also require an Ethernet CAT 5e cable
(not supplied), an accessible CAT 5e RJ45
socket, and an IP address with access to the
World Wide Web and a source of supply power
for the EQ LTE™ base station.
First, select the appropriate 'domestic' power
supply head and complete assembly of the
power supply. Insert the power supply jack
into the socket of the EQ LTE™ base station
and apply supply power. Following a device
boot sequence, the graphical user interface
will display.
Connect an Ethernet CAT 5e cable (not
supplied) to the RJ45 socket of the EQ
LTE™ base station and to an accessible
RJ45 socket with access to the World Wide
Web.
Establish an IP address for the EQ LTE™
base station using either DHCP or manual
input methods (see notes below).
Page 7