Table of Contents
Advertisement
screwdriver to unscrew and access the battery
compartment by removing the battery
compartment door.
When required to do so, change all batteries!
Take care to observe battery polarity when
inserting new batteries into the battery
compartment.
With the data loggers back
elevation facing you and the
logger orientated upright (when
the tamper resistant data logger
serial number and bar code are
above the battery compartment
door) batteries are inserted as
follows...
ONLY USE BATTERIES
RECOMMENDED IN THIS
4.2.7 Keypad
EQ LTE™ data loggers feature two keys on
the device front elevation identified by a key
symbol. Each key feature an associated LED
located directly above the key / symbol.
4.2.7.1 Bluetooth key & LED
When prompted by a base station to do so,
press the Bluetooth key...
Key location:
Front elevation, bottom left
Key symbol:
FLASHING
Key function:
Bluetooth operation
LED color:
Blue
LED
OFF
diagnostics:
Slow flash
Fast flash
(50ms on / 50ms off)
BATTERY COMPARTMENT LID
SCREW RETAINING THREAD
BATTERY GRIP
BATTERY GRIP
BATTERY COMPARTMENT LID
SCREW RETAINING THREAD
MANUAL
SOLID ON
Not paired
Searching for
base station
Pairing or
Transferring
data
ON
Time out:
1 minute
If a data logger has not found a
discoverable base station within one
minute, the search will end.
Try again
4.2.7.2 Diagnostic key & LED
Press the diagnostic key as necessary...
Key location:
Front elevation, bottom right
Key symbol:
FLASHING
Key function:
Logger diagnostics
LED color: Red
OFF
LED
diagnostics:
Troubleshooting: Check battery condition
and replace batteries as necessary
Slow flash
Troubleshooting: Create audit
configuration, transfer from cloud to base
station and then from base station to
logger
Fast flash
Troubleshooting: Check installation
Fast flash
Fast flash
Troubleshooting: Check installation
Paired
SOLID ON
Low batteries
Not configured
Configured,
not sensing
data
All data
loggers
except
current and
volt logger...
Configured,
sensing valid
data
Current and
volt logger
only...
Configured,
sensing
current data,
not sensing
valid voltage
data
Current and
volt logger
only...
Page 12
Advertisement
Table of Contents
