Connector Data; Connection Data - Fagor DDS Series Hardware Manual

  Drives
3.
180
DDS
HARDWARE
Ref.1912
· 134 ·
X7 connector
X7. Status of the safety r elay
This connector X7 of the modular drive is associated with the second contact
(N.C., Normally Closed) of an internal safety relay (with guided contacts).
The status of the relay (initially closed) may be acknowledged through the
two pins and a CNC, PLC or control panel, i.e. that the integrated safety
relay has actually opened or closed. These two terminals are identified at
the drive as AS1-AS2. The opening or closing of this relay depends on
whether 24 V DC are present or not at pin 2 «Drive Enable» of control
connector X2. For further detail on this connector, see section 9.2. Drive
Enable input and AS1-AS2 feedback output of chapter 9. FUNCTIONAL
SAFETY in this manual.
F. H3/74
X7 connector. External acknowledgment of the status of the integrated
safety relay.
The following table shows the values for gap, tightening torque, sections
and other data of aerial plug-in connector X7:
T. H3/12 Pins of aerial plug-in connector X7. Technical data.
AXD|SPD|MMC

Connector data

Nr of poles
Gap (mm)
Min./max. tightening torque (N·m) 0.5/0.6 0.5/0.6
Screw thread
Min./max. section (mm²)
x1
Rated current In (A)

Connection data

Length to strip (mm)
1
2
INTERNAL
RELAY CONTACT
1.XX 2.XX 3.XX
2 2 2
5 5 5
0.5/0.6
M3 M3 M3
0.2/2.5 0.2/2.5 0.2/2.5
12 12 12
7 7 7
AS1
AS2