Operation; Positioning Instructions - HAMPTON BAY HD10 Use And Care Manual

Operation

□ The heater, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.
□ Certain materials or items, when stored under the heater, will be subjected to radiant heat and could be seriously damaged.
□ Inspect the visible portion of the hose before each use of the appliance. The hose inside cylinder pole housing should be checked
annually and a leak test should be performed when re-assembled.
□ Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing
ignition.
□ Young children should be carefully supervised when they are in the area of the heater.
□ Clothing or other flammable materials should not be hung from the heater, or placed on or near the heater.
□ Any guard or other protective device removed for servicing the heater must be replaced prior to operating the heater.
□ Installation and repair should be done by a qualified service person. The heater should be inspected before use and at least
annually by a qualified service person.
□ More frequent cleaning may be required as necessary. It is imperative that control compartment, burners and circulating air
passageways of the heater be kept clean.
□ Keep the appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids.
□ Do not obstruct the flow of combustion and ventilation air.
□ Keep the ventilation openings of the cylinder enclosure free and clear from debris.
□ The LP-gas supply cylinder to be used must be: a. Constructed and marked in accordance with the specifications for LP-gas
cylinders of the U.S. Department of Transportation (DOT); or the Standard for cylinders, Spheres and Tubes for Transportation of
Dangerous Goods and Commission, CAN/CSA-B339, as applicable; b. Provided with a listed overfilling prevention device; and c.
Provided with a cylinder connection device compatible with the connection for the appliance. d. 20LB (9kg) cylinder. LPG capacity
4.7 gallons (17.8 litres) Cylinder Dimensions: Height 17.75 in. (451 mm) and width 12.25 in. (311 mm) e. The LP - gas cylinder used
must include a collar to protect the cylinder valve.
□ A cylinder must be stored outdoors in a well-ventilated area out of reach of children. A disconnected cylinder must have dust caps
tightly installed and must not be stored in a building, garage or any enclosed area. The pressure regulator and hose supplied must
be used and any replacement pressure regulator or hose must be those as specified by the manufacturer.
□ Do not store spare LP-gas cylinder under or near this appliance.
□ Never fill the cylinder beyond 80% full; and for appliances designed to use a CGA No. 791 Connection: Place the dust cap on the
cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the cylinder valve that is provided with
the cylinder valve. Other types of caps or plugs may result in leakage of propane.

POSITIONING INSTRUCTIONS

□ This appliance is for OUTDOOR USE ONLY and should be placed in a well ventilated area.
□ A well ventilated area must have a minimum of 30% of its surface area open. (Surface area is defined as the total surface of the
walls surface.)
□ The sides of the appliance should NEVER be closer than 40 in. (1 m) from any combustible surface.
□ Keep this appliance away from any flammable materials!
14
40 in. (1M)
40 in. (1M)