System Settings - gefran eView HD IP67 Series Operating Instructions Manual

eView HD IP67 HMI products have a system settings interface
to allow configuration of system options.
The user interface of System Settings is based on HTML
pages accessible from the HMI screen or remotely using a
Web browser Chrome v44 or higher using port 443. To connect
The active item of menu is highlighted on the left side of the
screen. The right side shows related information and settings.
Depending on the size of the HMI screen, both menu and
content of selected item may be shown on screen at the same
time or not.
System Settings has two modes of operation:
User Mode GF Designer HD runtime is running or the
System Mode HMI device is in "factory default" status.
GF Designer HD runtime is not running
or the HMI device has a software failure.
System Mode includes all options
available in User Mode and additionally
includescommands dedicated to system
upgrade and recovery not available when
running in User Mode.
Activation of System Settings in User Mode:
Factory default Press "System Setting" button on the
status HMI screen
GF Designer HD Recall context menu and select "System
Settings". To recall the context menu
runtime running
click and hold any unused area of the
touchscreen for a few seconds. Default
hold time is 2 seconds.
Activation of Systems Settings in System Mode:
If GF Designer HD runtime is not running:
Normal
Press "System Setting" button on the
operation
device screen to recall System Settings
in User Mode. Select "Restart" -> "Config
OS" to reboot in System Mode.
If GF Designer HD runtime is running:
recall context menu and select "System
Settings".
18

10. SYSTEM SETTINGS

enter the address https://IP/machine_config where IP is the
IP address of the HMI device. Default username is "admin",
default password is "admin". Use navigation menu on the left
side of the screen to browse through the available options.
To recall the context menu click and hold
any unused area of the touchscreen for
a few seconds. Default hold time is 2
seconds to enter in System Settings in
User Mode. Select "Restart" -> "Config
OS" to reboot in System Mode.
Recovery If device is not responsive, use the so-
called "tap-tap" procedure.
operation
This procedure consists in tapping the
surface of the touchscreen during the
device power-up phase. Tapping frequency
must be high.
You have to start tapping the touchscreen
as soon as power has been applied
to the device. When the sequence has
been recognized, the system shows the
message: "TAP-TAP DETECTED". At this
point release touch to boot in User Mode
without running GF Designer HD runtime
or press and hold few seconds (selecting
so "RESTART: CONFIG OS") to boot in
System Mode.
System Settings includes options for basic settings of the
device:
Configure language used for System
Language
Setting menu only.
System
Show information about platform, status
and timers (like System on time, backlight
on time).
Enable persistent log for BSP and allows
Logs
exporting it.
Date & Time
Change the device date and time, including
time zone and NTP Server
80588_eView HD IP67_02-2019_ENG