Reset Memory - PROEL PLBR8DJ User Manual

Table of Contents

Available languages

Press the Program button to quit from running, the relevant Program LED will go

out.

Mix Programs

Pressing two or more Program buttons at a time allows you to mix programs. The

selected programs will run synchronously.

Running Programs With Speed Fader (or Tap Sync)

You can run the programs with preset programming speed or Speed Fader (Tap

Sync). The Program LED will blink briefly when it is running with Speed Fader (Tap

Sync), whereas the Program LED will blink at intervals when it is running with

preset programming speed. Press and hold down the relevant Program button,

then press the Speed+Fade button to change running mode between Speed Fader

and preset Programming speed.

Running Programs With Fade Time

When the program is running with Speed Fader (Tap Sync), you can press the

Speed + Fade to enable or disable Fade Time function. When Fade Time is enabled,

the Speed fader will serve speed and fade time control. When Fade Time is

disabled, the Speed fader will serve Speed control only.

Audio Running

Press the Audio/Preview button, the relevant LED will be lit indicating Audio is

activated. In Audio mode, all selected programs will run with the beat of music

rhythms. Press the button again to quit Audio mode, its LED will go out

accordingly.

Manual Channel Fader & Reinstate Program

You can use channel faders to control the relevant fixtures at any time. There is no

exception when the program is running. If you want to recall the channel, you can

press the relevant Program button for one second to reinstate the program.

RESET MEMORY

This function allows you to dump memory. Switch the power off, next press and

hold down the Scene No. 2, Bank and Blackout buttons synchronously, then you

can switch the power on to reset memory. It will take you several seconds.

A caveat: Doing reset frequently will do harm to the memory.

Table of Contents

Table of Contents