Advertisement
instabus rf
Technical Product Information
January 2005
Binary Input wave AP 261
Electrical safety
• Pollution degree (according to IEC 60664-1): 2
• Protection (according to EN 60529): IP 20
• Overvoltage category (according to IEC 60664-1): III
• Device complies with EN 60669-2-1 and IEC 60664-1
Electromagnetic compatibility
complies with EN 301489, EN 300220
Environmental specifications
• Climatic conditions: EN 50090-2-2
• Ambient operating temperature: - 5 ... + 45°C
• Storage temperature: - 25 ... + 70°C
• Relative humidity (non-condensing): 5% to 93%
Certification
complies with
- standard
radio frequency rf
-
easy mode push button EP
-
CE norm
complies with the EMC regulations (residential build-
ings),
low voltage regulations and R&TTE regulations:
The CE declaration can be inspected at:
SIEMENS AG
Siemensstraße 10
93055 Regensburg
Installation Instructions
Caution:
• The device may be used for interior installations and in
dry rooms only.
• The device may not be opened for warranty reasons.
• Occasionally the transmission range may be influ-
enced by structural conditions (e.g. reinforced con-
crete) or electric / electronic sources of interference.
• A minimum distance of 1 m must be maintained be-
tween the binary input wave and the relevant receivers.
• Although the radio transmission is carried out in the
safe 868 MHz range, disruptions to the radio transmis-
sion cannot be excluded.
• This product is not suitable for security applications in
professional alarm systems.
Technical Manual
Update: http://www.siemens.de/gamma
2.20.3.2/2
Mounting
It is advisable to attach the radio-controlled sensor to the
fixed door/window frame and to attach the magnet to the
movable door or window. The mounting plate (B2) of the
binary input (B1) as well as the magnet (B3) can be fixed
using the supplied adhesive strips or with screws if nec-
essary. When using the adhesive strips the ground must
be clean and non-greasy. It should be ensured that the
SIEMENS markings on the mounting plate and magnet
lie on top of each other as much as possible (Diagram B)
and that the distance (gap) between the mounting plate
and the magnet is at least 3 mm but does not exceed
10 mm. With the magnet at this distance from the binary
input, the internal reed contact is closed.
min. 3mm
max. 10mm
Before clipping the radio-controlled sensor onto the
mounting plate, the insulating strip (C4) that is inserted in
the battery compartment (C1) on the back of the sensor
must be removed and if necessary an external contact
should be connected.
wave AP 261, 4 pages
Siemens AG 2005
Subject to change without prior notice
5WG3 261-3AB11
Diagram B
C1
C2
C4
C5
C3
Diagram C
Siemens AG
Automation and Drives Group
Electrical Installation Technology
P.O. Box 10 09 53, D-93009 Regensburg
B1
B2
B3
Advertisement
