Zfh (Single Arm Type, Double Arm Type) - Yamaha XY-X series User Manual

2. ZFH (single arm type, double arm type)

2. ZFH (single arm type, double arm type)
When using the 3rd-axis model with ZFH for the 3rd-axis, install the workpiece onto the
ZFH slider by using four M5 coarse thread tap holes and a φ 5 reamer hole opened on
the slider's workpiece installation surface. The tap depth is 9mm. There is a step on the
top of the slider. The actual tool installation surface is the shaded section shown in the
drawing.
Chapter
4
c
CAUTION
If the bolt fi tting length is 9mm or more from the installation surface, the bolt will
contact the bottom.
4-2
A
70
(Tolerance between knock (0.02)
31 28
SEC A-A
4-M5x0.8 Depth 9
2- 5H7 Depth 8
A
31