SOMFY Sonesse ULTRA 30 Wirefree RTS Quick Programming Manual

BEFORE YOU BEGIN: Check if you have a paired transmitter with the following directions:
1) BRIEFLY PRESS the PROGRAMMING BUTTON on the motor or plug in the charger.
The motor will jog once. (A jog is a brief up and down motion).
2) If the transmitter was supplied, press a directional button (UP or DOWN) and see if the shade operates. If a multi-channel
transmitter was supplied, try on each channel.
a) If the shade operates - the shade is already programmed.
b) If the shade does not operate - choose the transmitter channel on which you would like to control the shade.
PRESS & HOLD the PROGRAMMING BUTTON on the motor until it jogs once. Then BRIEFLY PRESS
the PROGRAMMING BUTTON on the transmitter. The shade will jog once. The shade is now programmed.
INITIAL PROGRAMMING AND LIMIT SETTING
NOTE: Steps 1-6 must be completed to ensure proper shade programming and functionality. Motor will exit programming mode after 2 minutes of inactivity.
While in programming mode, the shade only operates when the UP or DOWN buttons are continuosly pressed. Releasing the buttons stops the shade.
Step 1:
To initiate programming PRESS
& HOLD both the UP and DOWN buttons
at the same time until the shade jogs.
Step 3:
Bring the shade to your desired
upper limit. PRESS & HOLD both the MY/
STOP and DOWN buttons until the shade
begins to move down, then release. Stop the
shade at the desired lower limit, adjust by
pressing the UP or DOWN buttons.
ADJUSTING THE LIMITS IN USER MODE
Step 1:
Move the shade to
the current limit position you
wish to adjust and let it stop.
Adjusting the
upper limit:
Adjusting the
lower limit:
Copyright © Somfy SAS 8/2019
Sonesse ULTRA 30 Wirefree (Li-Ion) RTS
Quick Programming Guide
Step 2:
Check the direction of operation.
Press the DOWN button and confirm the
shade lowers.
Step 4:
PRESS & HOLD the UP
and MY/STOP buttons until the
shade begins to move up.
The shade will stop at the original
upper limit. Adjust if necessary.
Step 2:
PRESS & HOLD both
UP and DOWN buttons
simultaneously until the shade
jogs, then release.
If the shade raises instead of closing, change the direction -PRESS
& HOLD the MY/STOP button until the shade jogs.
Confirm correct direction of operation before proceeding.

Step 5:
PRESS &
HOLD the MY/STOP
button until the shade
jogs to confirm both
limit settings.
Step 3:
Adjust to a new
limit position using the
UP or DOWN buttons.
OR
OR
P-0038
Programming
Button

Step 6:
To finalize BRIEFLY PRESS the
PROGRAMMING BUTTON on the back
of the control. The shade will jog and will
now operate in user mode. Brief press
of the UP or DOWN button will send the
shade to the respective limit.
Programming
Button
Step 4:
PRESS & HOLD the
MY/STOP button until the
shade jogs, then release.
Check the new limit.