Table of Contents
Advertisement
Place your foot gently on the
head of the vacuum and pull
the body back towards you.
You will hear a click.
Removing and cleaning the brush bar
Before you remove the brush bar, you will
need to remove the power floor head from
the extension tube. Rotate the latch on the
side of the powered floor head to the 'unlock'
position and pull out the brush bar.
A forward motion will pick up
larger pieces of debris.
To remove hair from the brush bar, use the
hair removal tool to cut the hair before pulling
it out. Never operate the power floor head
without the brush bar in place.
Pulling the vacuum back
towards you activates the
AirLOC and picks up
finer particles.
7
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Pro2 and is the answer not in the manual?
Questions and answers
The m/c runs for about a min. then stops when put on charge the green lights go on and off
The Gtech Pro 2 may stop running after about a minute due to a low battery. The flashing green lights indicate that the battery is charging. Recharge the battery fully (which takes 4 hours) before using the vacuum again. If the issue persists, check for blockages or other obstructions.
This answer is automatically generated